Rally-armor 2013+ Ford Focus User Manual download pdf (Page 2)

IMF 27

Version 1.1 Release Date 05.12.2013 2

Front Mud Flap Installation

Begin by parking the vehicle on an even surface. Turn the steering wheel as to allow access to the inner wheel well area.

• (Figure A) Remove the three OEM fender liner fasteners. Pull liner away to gain access to the interior fender area.

• (Figure B) Place 3 round edge clips over mounting tabs (as shown). Replace liner over the mounting points.

• (Figure C) Place a round edge clip over lowest mounting point of front bracket. Lay front bracket against logo side of the mud flap.

• (Figure D) Place the mud flap with the logo facing the rear of the vehicle, against the corresponding mounting points on the fender

liner and bracket. Place a washer (SmWash) over a medium screw (1.5SS) of the original screws through the flap into the mounted clips.

Use a short screw (1SS) with a washer for the lowest mounting point on the bracket. Do not fully tighten screws prior to aligning the

mud flap.

• (Figure E) Expanded diagram. TIP: Ensure the clip mounting points are visible through the liner prior to inserting the screws. You

can align them with a small pick or screw driver if needed, then align the screw by hand threading the first few turns. The screw must

thread through the rear of the clip.

• (Figure F). Align outer edge of the flap by incrementally adjusting the angle of the flap and bracket and walking away from the vehicle

until the flap is perpendicular to even ground. Tighten all mounting screws and bracket bolt only until snug and flush with the surface

of the mud flap. Do not over tighten

1 2 3 4 5

No comments

Rally-armor 2013+ Ford Focus User Manual Page 2